Stove, Range & Oven Repair
in Port Orchard, WA
Oven not heating, burner not lighting or a fault code locking the door? Rabbit Appliance repairs electric and gas stoves, ranges and ovens across Port Orchard 7 days a week, with same-day visits for most early calls.
Call before lunch and there is a good chance a technician will be looking at your oven in Port Orchard that afternoon. That matters more for ovens than for most appliances, because people tend to discover the problem while cooking for someone. We work 7 days a week, 8:00 AM to 7:00 PM, and the drive from our East Bremerton shop around Sinclair Inlet to Bethel, Sedgwick, Bay Street or McCormick Woods fits comfortably into a same-day route. Later calls get the first opening the next morning, and we will tell you which it is when you call.
Port Orchard ranges fall into recognizable groups. The 1970s and 80s ramblers around Sunnyslope, Long Lake and Mullenix mostly have freestanding electric ranges, often GE, Whirlpool, Frigidaire or Kenmore, where a bake element, a surface element, an infinite switch or a thermostat is the usual repair. The newer homes near the golf course and off Sedgwick have slide-in ranges, double wall ovens and separate cooktops from KitchenAid, Bosch, GE Profile and Samsung, with more electronics and more things a control board can get wrong. Gas ranges turn up in both, though less often than electric.
Our technician tests before quoting. On an electric oven that means checking the element, the temperature sensor and the relay board with a meter. On gas it means watching the igniter glow, checking the safety valve and listening for the burner valves. For a fault code we pull the diagnostic history and test the component the code points to rather than trusting the code alone. You get a written finding and one written price, and most element, igniter, sensor and switch repairs finish on the first visit from van stock.

Common Oven & Range Problems in Port Orchard
Usually the bake element has weakened, or on a gas oven the igniter is glowing but no longer drawing enough current to open the valve fully. A temperature sensor drifting out of range causes the same complaint. On the double wall ovens in McCormick Woods, the upper and lower cavities each have their own parts, so we test the one that is misbehaving rather than assuming.
An element that sparked or shows a blister or break is finished, and it is one of the quickest range repairs we do on the older freestanding electrics in Port Orchard ramblers. The technician confirms the element is the only fault, since a short at the element can also take out a relay or fuse, and replaces it from the van. You will be baking again the same visit.
Constant clicking with no flame is often a wet or dirty spark electrode, a burner cap that is not seated, or a spark module that has failed. If one burner clicks even when the knob is off, the switch or a cracked electrode is usually the cause. We clean, test and replace what is needed. We work on the range and its connection, not the house gas piping.
Newer electric ovens lock the door for self-clean and sometimes stay locked after a fault. The code may point to the door lock motor, the temperature sensor or the control board. The technician reads the code, checks the sensor resistance and the lock circuit with a meter, and releases the door safely. Replacing a board without testing is a guess, so we do not do it.
On an electric coil or radiant cooktop, a burner that is either full blast or off has usually lost its infinite switch. On a radiant glass top the element itself or the limiter under the glass can be at fault. On induction tops in the newer kitchens, the problem is more often a power board. We test the switch and the element so the written price covers the actual failed part.
On the Job Across Kitsap
Meters first, opinions second. The crew doing what a visit actually pays for: measured diagnosis at the machine.
What's different about oven and range repair in Port Orchard
Port Orchard has a higher share of built-in cooking appliances than most of our map, thanks to McCormick Woods and the newer plats along Sedgwick and Bethel. Wall ovens set into cabinetry, slide-in ranges flush with the counter and separate cooktops dropped into stone all take more care to remove and more time to diagnose, because the controls are electronic and the fault is often a sensor or a board rather than a burned element. Our technicians are used to pulling these units without damaging trim or countertops. At the same time, the ramblers from Sunnyslope to Retsil keep us busy with simple freestanding electrics where an element or switch is the whole repair. Both get the same approach: meter first, written price, one visit when the part is on the van.
Oven & Range Repair in Port Orchard: Asked Often
Can you work on the double wall oven in our McCormick Woods kitchen?
Yes. Double wall ovens from KitchenAid, Bosch, GE, Electrolux and the other major brands are regular work for us in the newer parts of Port Orchard. Each cavity has its own element, sensor and sometimes its own board, so we test the cavity that is failing. The unit is heavy and sits in cabinetry, so we bring the right support and protection to pull it, diagnose, and reinstall it cleanly.
Our gas range will not light. Do you handle gas?
We repair the gas range itself: igniters, spark modules, electrodes, burner valves and the oven safety valve. What we do not do is run, alter or test the gas piping in the house, so if the issue is the supply line, the shutoff or a propane tank out on a rural lot, we will say so and hand that part to a plumber or your gas supplier. Most no-light calls, though, are a range part we carry on the van.
The oven is cooking unevenly, burnt on one side and raw on the other. Is that a repair?
Often it is. Uneven baking usually means one element is weak, the convection fan has stopped, or the temperature sensor is reading wrong so the oven cycles at the wrong point. Sometimes the door gasket has flattened and heat is escaping on one side. Our technician checks each of these, and the written finding will say whether it is a part or simply the oven's design and rack position.
The range is from the 1980s and still works except for the oven. Can you get parts?
For most of the common older GE, Whirlpool, Frigidaire, Kenmore and Hotpoint ranges in Port Orchard, yes. Bake elements, surface elements, infinite switches and thermostats for those models are still available and often on the van. If a specific part is no longer made, the technician will tell you at the diagnosis so you can decide before anything is ordered, with the finding in writing in front of you.
Can you come on a Sunday before we host dinner?
Yes. Sundays are regular hours for us, 8:00 AM to 7:00 PM, and Port Orchard is a standard part of the weekend route. Call as early in the day as you can; a Sunday call before early afternoon usually gets a same-day visit. Have the model number from the sticker inside the oven door frame or the drawer ready, and tell us the symptom so the technician brings the right parts for that model.
Other Machines We Repair in Port Orchard
Dryer Repair in Port Orchard
Dryers in Port Orchard fight damp air for half the year, and a long vent run through a crawl space or up an exterior wall slows them down further. We repair heating elements, gas igniters, thermal fuses, drum rollers and belts, and we check the vent path on every visit, because a new element will fail again behind a blocked duct.
Washer Repair in Port Orchard
From stacked units in Bay Street cottages to big front-loaders in McCormick Woods, we fix washers that will not drain, will not spin, leak, shake or stop mid-cycle. On well-water homes around Long Lake and Mullenix we pay attention to inlet screens and valves, where sediment causes slow fills and false error codes.
Refrigerator & Freezer Repair in Port Orchard
Warm fridge, frozen-over evaporator, a compressor that runs without stopping, water pooling under the crisper drawers. We diagnose cooling systems, defrost circuits, fans and control boards on everything from a basic top-freezer in a Retsil rambler to a counter-depth French door in a Sedgwick subdivision, and we handle garage freezers too.
Ice Maker Repair in Port Orchard
An ice maker that stops, makes small cloudy cubes or dumps water into the bin is one of the most common calls from Port Orchard, especially in homes on wells where the fill valve and filter take a beating. We service built-in fridge ice makers and freestanding units, and we start by checking water supply and filter condition.
Dishwasher Repair in Port Orchard
Cloudy glasses, standing water in the bottom, a door that leaks on the floor, a cycle that never finishes. We repair dishwasher pumps, drain systems, inlet valves, heaters and control boards, including the panel-front models in Port Orchard's newer kitchens and the older built-ins still working hard in 1970s ramblers.
Read Next
Oven Temperature Running Hot or Cold: A Kitsap Troubleshooting Guide
Burnt bottoms and underdone centers often trace back to oven temperature. Learn how an oven cycles, how to run a thermometer test, when the calibration offset is the right fix, and when a drifting sensor, convection fan, or leaking door gasket means a Port Orchard service call.
Read the guide →Oven Not Heating in Bremerton: What to Check Before You Call
An oven that lights up but never gets hot usually comes down to the bake element, a weak gas igniter, the temperature sensor, or a fuse tripped by self-clean. Here is how Bremerton homeowners can narrow it down without tools, and where it becomes a meter job.
Read the guide →Gas Range Burner Won't Light: What Kitsap Homeowners Can Check
A gas burner that clicks without lighting is usually wet, dirty, or reassembled crooked. This guide covers the safe checks, the spark module and switches, propane versus natural gas around Poulsbo and the north end, and the gas-safety lines no homeowner should cross.
Read the guide →The McCormick Woods Wall Oven Locked After Self-Clean
A built-in electric wall oven in a McCormick Woods home ran self-clean the evening before a dinner, then refused to unlock or heat. The latch motor had stalled and the thermal fuse behind the control had opened from the heat.
Read the case →The Tracyton In-Door Ice Maker That Went Quiet
An in-door ice maker on a French-door refrigerator in a Tracyton waterfront house simply stopped, no noise and no puddle. The fill tube had frozen solid because the inlet valve passed only a trickle, and the trickle froze before it reached the mold.
Read the case →Oven & Range down in Port Orchard?
Stove, range or oven trouble in Port Orchard? Call (360) 717-8985 for a same-day visit when you call early, 7 days a week, electric or gas, freestanding or built-in.






