Dishwasher Repair
in Port Orchard, WA

Rabbit Appliance repairs dishwashers across Port Orchard every day of the week, from older built-ins in Sunnyslope ramblers to panel-front units in McCormick Woods. Call before early afternoon for a same-day visit in most cases.

✓ Open 7 days a week — Port Orchard is on every day's route✓ Same-day visits when you call early✓ One written price after diagnosis, approved by you

Get a Visit on the Books

Tell us what the machine is doing. We call back with a window and get you on today's route when the clock allows.

$20 OFF code HOP20 rides along with this request — it comes off any completed repair.

We diagnose first, then hand you one written price. Nothing is installed until you approve it.

7 days a week, 8 AM – 7 PM• Same-day visits when you call early• Written price after diagnosis, approved by you• Warranty on parts and labor, on the invoice

Bosch, KitchenAid and the quieter end of the Whirlpool and GE lines are what we find under the counters in Port Orchard's newer kitchens, and they have made dishwasher repair more of an electronics job than it used to be. In McCormick Woods and the subdivisions off Sedgwick and Bethel, a dishwasher that stops mid-cycle, refuses to start or flashes a code is often a control board, a flow meter, a turbidity sensor or a door latch sensor rather than a worn pump. The older built-ins in the ramblers around Long Lake, Sunnyslope and Retsil fail the classic way: drain pump, wash pump, inlet valve, heater, door gasket.

Water quality matters here too. Dishwashers on well water in the outer parts of Port Orchard fight scale and sediment. The inlet valve screen clogs, the heater and spray arms pick up mineral crust, and glasses come out with a white film that no amount of rinse aid fixes. On septic, homeowners also tend to notice leaks and slow drains sooner, because they are paying attention to what goes into the ground. Our technicians know to check the supply side and the drain path on these homes before quoting a part, since a scaled valve or a clogged air gap is cheaper to fix than a pump.

The visit starts by running the dishwasher and watching. The technician checks that it fills to the right level, listens to the wash pump, confirms the heater is drawing current with a meter, watches the drain and looks for the leak at the moment it happens. A written finding comes next, then one written price, and nothing is installed until you approve it. Drain pumps, inlet valves, gaskets, heaters and the more common boards are stocked on the van, so most dishwasher repairs in Port Orchard are finished in a single visit.

Dishwasher control panel showing a diagnostic readout
Panel readout mid-diagnostic — the machine tells its side of the story.
What we hear from Port Orchard

Common Dishwasher Problems in Port Orchard

Dirty water sitting in the bottom after the cycle

The dishwasher is not draining. On most models the drain pump is blocked with a bit of glass, a label or a seed, or the pump has failed. A kinked drain hose under the sink, a clogged air gap or a garbage disposal with the knockout plug still in place cause the same thing. The technician checks the whole drain path, clears what can be cleared and replaces the pump only if it has actually failed.

Glasses come out cloudy or with a white film

On Port Orchard well homes this is often mineral scale, and the fix is matching the detergent and rinse aid to the water, plus cleaning the spray arms and filter. On any home it can also be a heater that no longer gets the water hot enough, or a dispenser that is not opening on time. We test the heater with a meter and check the dispenser so you get a repair rather than a guess.

Water on the floor in front of the door

A leak at the door is usually a worn or hardened door gasket, a spray arm that has cracked and is throwing water at the seal, or too much suds from the wrong detergent. On the newer panel-front units in McCormick Woods a leak from the base can also trip the flood switch and stop the machine entirely. We find where the water is coming from while it runs, then fix that spot.

Starts, hums, then stops and will not go on

A dishwasher that quits partway through is often a wash pump motor that has seized or a control board that is dropping out. On electronic models we pull the fault history before touching anything. On older built-ins a timer or a thermostat can cause it. Because the board and the pump are very different repairs, the technician tests both and writes down which one it is before quoting.

Dishes come out still dirty on the top rack

Poor washing on the upper rack points to a spray arm that is clogged or not spinning, a wash pump that has lost pressure, or a filter packed with debris. In well-water homes the spray arm holes scale shut over time. We clean or replace the arm, check the pump and the filter, and confirm the fill level, since a dishwasher that underfills will never wash the top rack well.

From the routes

On the Job Across Kitsap

Meters first, opinions second. The crew doing what a visit actually pays for: measured diagnosis at the machine.

Dishwasher control panel showing a diagnostic readout
Panel readout mid-diagnostic — the machine tells its side of the story.
Spray arm and filter area inside a built-in dishwasher
Inside a built-in dishwasher — spray arm off, filter out, checking what the owner never sees.
Open built-in dishwasher with racks visible during a door and latch inspection
Door, latch and rack inspection on a kitchen built-in.
Stainless dishwasher in a kitchen before service
A kitchen stop — stainless front, wood floor, dog supervising off-frame.
Technician testing a French-door refrigerator with a multimeter
Refrigerator call — readings before any part gets named.
Technician metering an electric dryer in a garage laundry area
Garage-laundry dryer, meter on the heater circuit.
Range and oven control panel being checked during a service call
Oven controls going through their paces — locked panels after self-clean are a regular call.
Front-load dryer on a pedestal next to the matching washer
Pedestal laundry pair waiting its turn — tight quarters, standard work.
Local angle

What's different about dishwasher repair in Port Orchard

Port Orchard gives us both ends of the dishwasher world in one town. The newer homes near the golf course and along the Sedgwick and Bethel corridors have quiet, electronic machines, many with cabinet panels on the front, where the challenge is diagnosing a sensor or board accurately and removing the unit without marking the cabinetry. The ramblers and bungalows from Annapolis to Long Lake run older built-ins where pumps, valves, heaters and gaskets are the regular work. On top of that, well water in the rural parts adds scale and sediment that municipal homes do not see. Our technicians carry parts for both generations, treat the water supply as part of the diagnosis, and give every Port Orchard home the same written finding and written price before any part is installed, 7 days a week.

How a Port Orchard visit runs: you call or send the form; we come back with a window (today, when the clock allows). At the machine we measure before we name a part, write down the finding, and give you one price. You approve it, then we fix it — usually in the same visit from van stock. Parts and labor are warrantied on the invoice.
Fair questions

Dishwasher Repair in Port Orchard: Asked Often

Our Bosch has a cabinet panel on the front. Can you still get it out and repair it?

Yes. Panel-front dishwashers are common in the newer Port Orchard kitchens and we service them regularly. The technician releases the unit from the counter and cabinet, protects the floor and the adjacent cabinet faces, and reinstalls it level and aligned when the repair is done. Bosch, KitchenAid, GE, Electrolux and the other major brands all fall within what we repair, including their control boards and sensors.

We are on a well and the dishwasher leaves everything white. Is that the machine or the water?

Usually the water, sometimes both. Mineral scale from well water coats glasses and builds up on the heater and spray arms. The technician checks the heater, the dispenser and the fill level to make sure the machine is doing its job, cleans the arms and filter, and will tell you plainly whether a different detergent and rinse aid setup will solve it or whether the water needs treatment ahead of the dishwasher.

The dishwasher will not drain and we are on septic. Is there anything I should do before you arrive?

Turn the dishwasher off, scoop or bail the standing water into the sink and leave the door latched. Do not run the disposal repeatedly hoping it will clear; if the drain hose is the problem, that will not help. When you call, give us the brand and model and tell us whether the kitchen sink drains normally. The technician will check the pump, hose and air gap in order and give you a written price for the actual fault.

Is a ten-year-old built-in in our Sunnyslope rambler worth repairing?

Often it is. A drain pump, inlet valve, gasket or heater puts an older Whirlpool, GE, Kenmore or Frigidaire built-in back in service for years, and those parts are usually on the van. If the tub is rusted through or the main pump and board have both gone, the technician will say so in the written finding and you can decide from there. We do not install anything until you have approved the price.

How quickly can you get to Port Orchard for a dishwasher?

Call before early afternoon and it is usually the same day. Our technicians come around through Gorst from East Bremerton, and Port Orchard is a regular part of the daily route, 7 days a week including Saturdays and Sundays. Later calls get the first opening the next morning. A dishwasher is rarely an emergency, but a leak is, so if you see water under the unit tell us when you call and we will try to move it up the list.

Also in Port Orchard

Other Machines We Repair in Port Orchard

Dryer Repair in Port Orchard

Dryers in Port Orchard fight damp air for half the year, and a long vent run through a crawl space or up an exterior wall slows them down further. We repair heating elements, gas igniters, thermal fuses, drum rollers and belts, and we check the vent path on every visit, because a new element will fail again behind a blocked duct.

Washer Repair in Port Orchard

From stacked units in Bay Street cottages to big front-loaders in McCormick Woods, we fix washers that will not drain, will not spin, leak, shake or stop mid-cycle. On well-water homes around Long Lake and Mullenix we pay attention to inlet screens and valves, where sediment causes slow fills and false error codes.

Refrigerator & Freezer Repair in Port Orchard

Warm fridge, frozen-over evaporator, a compressor that runs without stopping, water pooling under the crisper drawers. We diagnose cooling systems, defrost circuits, fans and control boards on everything from a basic top-freezer in a Retsil rambler to a counter-depth French door in a Sedgwick subdivision, and we handle garage freezers too.

Stove, Range & Oven Repair in Port Orchard

Electric ranges that heat unevenly, bake elements that have gone dark, gas burners that click without lighting, wall ovens that throw a fault code and lock the door. We repair stoves, ranges and ovens across Port Orchard, including the built-in and slide-in units common in newer homes near the golf course.

Ice Maker Repair in Port Orchard

An ice maker that stops, makes small cloudy cubes or dumps water into the bin is one of the most common calls from Port Orchard, especially in homes on wells where the fill valve and filter take a beating. We service built-in fridge ice makers and freestanding units, and we start by checking water supply and filter condition.

Dishwasher Repair elsewhere on the map: Bremerton · Silverdale · Poulsbo · Tracyton · Manchester · all of Kitsap
From the notebook

Read Next

 Troubleshooting · 6 min read

Dishwasher Not Cleaning Dishes in Bremerton: Where to Look First

Dishes coming out gritty or filmy after a full cycle? Start with the spray arms and the filter, then check water temperature, detergent dosing for soft Kitsap water, and loading. This guide for Bremerton and Silverdale homes explains which fixes are yours and which need a technician.

Read the guide →
 Troubleshooting · 6 min read

Dishwasher Not Draining in Kitsap County: Safe Checks Before You Call

Standing water after the cycle usually means a blocked sump, a kinked or unlooped drain hose, a clogged air gap, or a disposal knockout that was never removed. Work through the safe checks in order, with notes for well-water homes around Manchester, and know when the pump needs a meter.

Read the guide →
 Troubleshooting · 6 min read

Washer Won't Drain in Kitsap County: Safe Checks Before You Call

A washer full of standing water in Port Orchard usually comes down to a clogged pump filter, a sock in the impeller, a drain hose at the wrong height, or a lid lock that will not engage. Here is how to check each one safely, drain the tub by hand, and know when to call.

Read the guide →
 Liberty Bay, Poulsbo

The Poulsbo Dishwasher That Would Not Drain on a Sunday

A dishwasher above Liberty Bay held an inch of dirty water on a Sunday morning with company due that evening. A same-day weekend visit found broken glass packed into the sump and a drain hose lying flat under the sink.

Read the case →
 McCormick Woods, Port Orchard

The McCormick Woods Wall Oven Locked After Self-Clean

A built-in electric wall oven in a McCormick Woods home ran self-clean the evening before a dinner, then refused to unlock or heat. The latch motor had stalled and the thermal fuse behind the control had opened from the heat.

Read the case →

Dishwasher down in Port Orchard?

Need dishwasher repair in Port Orchard? Call (360) 717-8985. Same-day visits when you call early, 7 days a week, and a written price before any part is installed.