Washer Repair
in Port Orchard, WA

Rabbit Appliance repairs top-load and front-load washers throughout Port Orchard, Saturdays and Sundays included. Call before early afternoon and we can usually be there the same day with the common parts on the van.

✓ Open 7 days a week — Port Orchard is on every day's route✓ Same-day visits when you call early✓ One written price after diagnosis, approved by you

Get a Visit on the Books

Tell us what the machine is doing. We call back with a window and get you on today's route when the clock allows.

$20 OFF code HOP20 rides along with this request — it comes off any completed repair.

We diagnose first, then hand you one written price. Nothing is installed until you approve it.

7 days a week, 8 AM – 7 PM• Same-day visits when you call early• Written price after diagnosis, approved by you• Warranty on parts and labor, on the invoice

A 1970s rambler off Mile Hill Drive with a laundry room between the garage and the kitchen is about as typical a Port Orchard washer call as it gets. The machine is a top-loader from Whirlpool, Kenmore, Maytag or GE, the floor is vinyl, the drain goes into a standpipe behind the washer and the hot and cold hoses have not been changed since the last machine was installed. That setup has worked for years and then one morning it either will not drain, will not spin or has left a puddle. We see several of these a week, and they are usually a one-visit fix.

The other end of the range is just as familiar. Newer homes in McCormick Woods and the plats off Sedgwick and Bethel were sold with large-capacity front-loaders, often LG or Samsung, sometimes Electrolux or Bosch, with a laundry room upstairs or on a pedestal. Those machines are excellent until a door boot tears, a drain pump clogs with a sock, or a control board starts throwing codes that do not match any obvious fault. Down near Bay Street and in Annapolis there are stacked and compact units in closets where getting the washer out is half the job.

Water is the local wrinkle. Inside the city, Port Orchard is on municipal supply, but a lot of homes around Long Lake, Sunnyslope, Mullenix and the outer edges draw from wells. Sediment and minerals from well water collect in the inlet screens and valves, so a washer that fills slowly or stalls on a fill error may need its supply cleared before anything else. Our technician checks that first, tests the pump, motor and controls with a meter, writes down the finding and gives you one written price before any part goes in.

Front-load laundry pair on pedestals in a laundry room
Pedestal laundry pair waiting its turn — tight quarters, standard work.
What we hear from Port Orchard

Common Washer Problems in Port Orchard

Water left in the drum at the end of the cycle

The washer finishes, or seems to, and the clothes are sitting in water. On a front-loader this is usually a drain pump with something lodged in it, a kinked drain hose or a clogged filter at the pump. On a top-loader it can be the pump, the lid switch or a belt. The technician clears the obstruction if that is all it is, or replaces the pump from van stock if it has failed.

Leak on the floor during the wash

Where the water shows up tells the story. A puddle at the front of a front-loader is often a torn door boot. Water at the back points to hoses, the inlet valve or the drain connection. Water from underneath during spin can be a tub seal or a cracked pump housing. Before replacing anything, we run the washer and watch, because a wrong guess on a leak costs you the part and the second visit.

Banging and walking across the laundry room

A washer that shakes hard on spin usually has worn suspension rods or struts, a shock absorber that has given up, or a load that is simply out of balance. In older Port Orchard ramblers with a floor that gives a little, the problem shows up sooner. We check suspension, leveling and the tub bearing, since a rumbling bearing is a different repair than a loose rod and we want to quote the right one.

Fills very slowly or stops on a water error

This is the well-water complaint. Sediment packs the inlet screens and the valve cannot pass enough water, so the machine times out and shows an error. Sometimes a worn valve is the issue instead, or a pressure switch that no longer reads the level correctly. On homes around Long Lake and Mullenix we check and clean the screens as a matter of course before quoting a valve.

Dead, or starts and stops partway through

A washer that will not power on, or that pauses mid-cycle and will not resume, can be a door lock, a lid switch, a motor control board or the main board. On the newer electronic front-loaders in Sedgwick and McCormick Woods, we pull the error history and test components rather than swapping the board on a hunch. You get a written finding and one written price for the actual fault.

From the routes

On the Job Across Kitsap

Meters first, opinions second. The crew doing what a visit actually pays for: measured diagnosis at the machine.

Front-load dryer on a pedestal next to the matching washer
Pedestal laundry pair waiting its turn — tight quarters, standard work.
Technician testing a French-door refrigerator with a multimeter
Refrigerator call — readings before any part gets named.
Technician metering an electric dryer in a garage laundry area
Garage-laundry dryer, meter on the heater circuit.
Spray arm and filter area inside a built-in dishwasher
Inside a built-in dishwasher — spray arm off, filter out, checking what the owner never sees.
Range and oven control panel being checked during a service call
Oven controls going through their paces — locked panels after self-clean are a regular call.
Open built-in dishwasher with racks visible during a door and latch inspection
Door, latch and rack inspection on a kitchen built-in.
Dishwasher control panel showing a diagnostic readout
Panel readout mid-diagnostic — the machine tells its side of the story.
Stainless dishwasher in a kitchen before service
A kitchen stop — stainless front, wood floor, dog supervising off-frame.
Local angle

What's different about washer repair in Port Orchard

Two things stand out. The first is the spread of housing. Within a few miles we go from a Bay Street cottage with a stacked unit in a hall closet to a two-story home in McCormick Woods with a front-loader on a pedestal in an upstairs laundry room. Access, parts and failure modes are different for each, so our technician asks about the install when you call and stocks the van accordingly. The second is water. Outer Port Orchard homes on wells send us slow-fill and valve calls that we rarely get from municipal addresses, and septic systems mean owners care more about leaks and drain issues. We treat the supply side as part of the washer, not somebody else's problem, and we check it before quoting.

How a Port Orchard visit runs: you call or send the form; we come back with a window (today, when the clock allows). At the machine we measure before we name a part, write down the finding, and give you one price. You approve it, then we fix it — usually in the same visit from van stock. Parts and labor are warrantied on the invoice.
Fair questions

Washer Repair in Port Orchard: Asked Often

Our washer is upstairs in a McCormick Woods house. Is that a problem for a repair visit?

Not at all. Upstairs laundry rooms are common in the newer Port Orchard subdivisions, and our technicians are used to working in them. We bring floor protection and the tools to shift a front-loader off a pedestal if the repair needs it. We also pay extra attention to leak checks on an upstairs machine, since a drip that would be harmless on a garage slab can stain a ceiling below.

We are on a well near Long Lake and the washer takes forever to fill. Is the washer broken?

It may not be. The first thing we check on well homes is the inlet screens and the valve. Sediment packs the screens and starves the valve, and the washer times out or throws a fill error. If cleaning restores the flow, that may be the whole repair. If the valve itself has worn, we carry common valves in the van. Either way, the technician will show you what was found and give you one written price.

Can you fix the front-loader smell, or is that just how they are?

The smell comes from residue in the door boot and the drum, and sometimes from a drain pump that is holding water. We can clean and inspect the boot, replace it if it is torn or holding mold in the folds, and clear the pump filter. We will also show you how to leave the door ajar and run a hot maintenance cycle so it does not come back. It is a real fix, not a shrug.

The washer stopped with a code on the display. Do I need to tell you the code?

It helps. Give us the brand, the model number and the code exactly as it appears. Codes point the technician in the right direction before we arrive, which means the right parts are on the van. They are not the diagnosis, though. The technician still tests the suspect component with a meter, because a drain code can be a pump, a hose or a board, and the written price should match the real fault.

Do you come to Port Orchard on Sundays?

Yes. Our hours are 8:00 AM to 7:00 PM, 7 days a week, and we drive around to Port Orchard on Sundays just as we do on a Tuesday. A Sunday call before early afternoon usually gets a same-day visit. If your washer has quit with a load inside, call as early as you can so it is not sitting wet all day. Mention code HOP20 when you book for $20 OFF a completed repair.

Also in Port Orchard

Other Machines We Repair in Port Orchard

Dryer Repair in Port Orchard

Dryers in Port Orchard fight damp air for half the year, and a long vent run through a crawl space or up an exterior wall slows them down further. We repair heating elements, gas igniters, thermal fuses, drum rollers and belts, and we check the vent path on every visit, because a new element will fail again behind a blocked duct.

Refrigerator & Freezer Repair in Port Orchard

Warm fridge, frozen-over evaporator, a compressor that runs without stopping, water pooling under the crisper drawers. We diagnose cooling systems, defrost circuits, fans and control boards on everything from a basic top-freezer in a Retsil rambler to a counter-depth French door in a Sedgwick subdivision, and we handle garage freezers too.

Stove, Range & Oven Repair in Port Orchard

Electric ranges that heat unevenly, bake elements that have gone dark, gas burners that click without lighting, wall ovens that throw a fault code and lock the door. We repair stoves, ranges and ovens across Port Orchard, including the built-in and slide-in units common in newer homes near the golf course.

Ice Maker Repair in Port Orchard

An ice maker that stops, makes small cloudy cubes or dumps water into the bin is one of the most common calls from Port Orchard, especially in homes on wells where the fill valve and filter take a beating. We service built-in fridge ice makers and freestanding units, and we start by checking water supply and filter condition.

Dishwasher Repair in Port Orchard

Cloudy glasses, standing water in the bottom, a door that leaks on the floor, a cycle that never finishes. We repair dishwasher pumps, drain systems, inlet valves, heaters and control boards, including the panel-front models in Port Orchard's newer kitchens and the older built-ins still working hard in 1970s ramblers.

Washer Repair elsewhere on the map: Bremerton · Silverdale · Poulsbo · Tracyton · Manchester · all of Kitsap
From the notebook

Read Next

 Troubleshooting · 6 min read

Washer Won't Drain in Kitsap County: Safe Checks Before You Call

A washer full of standing water in Port Orchard usually comes down to a clogged pump filter, a sock in the impeller, a drain hose at the wrong height, or a lid lock that will not engage. Here is how to check each one safely, drain the tub by hand, and know when to call.

Read the guide →
 Brand Guide · 6 min read

Samsung Appliance Repair in Bremerton: What Breaks and What We Fix

Samsung washers, dryers and refrigerators fill a lot of Bremerton laundry rooms. This brand guide covers the complaints we hear most, from drain codes and spider arms to in-door ice makers that frost solid, plus what an owner can safely check first.

Read the guide →
 Brand Guide · 6 min read

LG Washer & Dryer Repair in Bremerton: Codes, Boots and Heat

LG laundry pairs are quiet, efficient and very common in Bremerton and up through Poulsbo. When they fail, they tell you with a code. This guide decodes the ones that matter, explains what a direct-drive motor does and does not break, and lists the owner checks worth doing first.

Read the guide →
 Ridgetop, Silverdale

The Ridgetop Front-Loader Full of Standing Water

A front-load washer in a Ridgetop townhome quit mid-cycle with six inches of water in the drum and the door locked. A morning call became a same-day visit, a manual drain, a sock pulled from the pump, and a decision about a wobbling pump.

Read the case →
 McCormick Woods, Port Orchard

The McCormick Woods Wall Oven Locked After Self-Clean

A built-in electric wall oven in a McCormick Woods home ran self-clean the evening before a dinner, then refused to unlock or heat. The latch motor had stalled and the thermal fuse behind the control had opened from the heat.

Read the case →

Washer down in Port Orchard?

Washer down in Port Orchard? Call (360) 717-8985 for a same-day visit when you call early, 7 days a week, with a written price before any part is installed.