Case note · Liberty Bay, Poulsbo

The Poulsbo Dishwasher That Would Not Drain on a Sunday

A dishwasher above Liberty Bay held an inch of dirty water on a Sunday morning with company due that evening. A same-day weekend visit found broken glass packed into the sump and a drain hose lying flat under the sink.

7 days a week, 8 AM – 7 PM• Same-day visits when you call early• Written price after diagnosis, approved by you• Warranty on parts and labor, on the invoice
MachineDishwasher RepairAreaLiberty Bay, PoulsboService lineDishwasher Repair in Poulsbo
The call

What the Owner Described

The call came at about half past nine on a Sunday from a 1970s house on the hill above Liberty Bay. The dishwasher had finished overnight and the owner opened it to find the bottom full of gray water. A wine glass had broken in the lower rack a few days earlier and she had picked out the big pieces. Family was coming for dinner, and because the call came early the Rabbit could get there by early afternoon.

Spray arm and filter area inside a built-in dishwasher
Illustrative photo from another service call, not from this repair.
At the machine

What We Measured

Readings taken before any part was named
Standing water on arrivalabout an inch above the filter
Drain pump with power appliedhums, no flow
Sump below the filterglass fragments wedged against the impeller
Impeller edgeone vane chipped
Drain hose under the sinkflat on the cabinet floor, no high loop
Drain time after repairempty in about ninety seconds

The filter came out and the water was bailed down to the sump, where the glass had gone. The big pieces the owner removed were not the problem; the slivers were. They had passed the coarse filter, settled into the sump, and been pulled toward the pump intake until they wedged against the impeller. The pump hummed but could not turn, and one vane had a chip where a shard caught it. A chipped impeller moves less water even once it is free.

The second finding was under the sink. The drain hose ran from the dishwasher straight across the cabinet floor to the disposal with no rise at all. A high loop, where the hose climbs to the underside of the counter before dropping to the drain, keeps sink water from flowing back into the dishwasher and gives the pump a clean path. Without it, dirty water from the sink could drift back into the tub between cycles, which explained the gray water.

The paper

What Was Written Down and Approved

The written finding listed three items: clear the sump of glass, replace the drain pump because of the chipped impeller, and re-route the drain hose with a proper high loop secured under the counter. The technician explained that the pump would likely run again once cleared, but with a damaged vane it would drain slowly and fail soon, and the part was already on the van. The owner approved all three. Nothing needed ordering, and the dinner timeline held.

Outcome: The sump was cleaned down to the bare housing with the last slivers lifted out by tweezers. The new drain pump went in from below, the hose was clipped high under the counter and reconnected to the disposal, and the tub was filled and drained twice: empty in about ninety seconds each time, nothing left standing at the filter. The invoice carried the parts-and-labor warranty line. The owner was shown how to check the sump after any breakage.
The takeaway

What this case teaches

Broken glass in a dishwasher is a sump problem, not a rack problem. The pieces you can see matter least. The slivers that slip past the filter are the ones that stop the pump, and once they chip the impeller the pump is on its way out even after it is cleared. The high loop is the other half: a free fix many Poulsbo kitchens are missing, and without it the tub collects sink water quietly for years.

A glass broke in my dishwasher. What should I do before the next cycle?

Remove the pieces you can see, then lift out the filter at the bottom of the tub and look into the sump with a flashlight. Lift any slivers out with tweezers, not fingers. Run a short rinse cycle empty and check the sump again. If the water does not drain or the pump hums, stop and call.

What is a high loop and why does it matter?

It is the rise in the drain hose under the sink, up to the underside of the counter before dropping to the disposal. It stops sink water from flowing back into the dishwasher and keeps the pump from working against a flat hose. If your hose lies flat on the cabinet floor, it needs a loop.

Does Rabbit Appliance come to Poulsbo on Sundays?

Yes. We run seven days a week, and a Sunday morning call usually gets a same-day slot if it comes in before early afternoon; later calls get the first opening the next morning. A dishwasher full of water on a weekend is exactly the kind of call that fits.

Everything about our dishwasher repair →  ·  All case notes →

From the notebook

Read Next

 Troubleshooting · 6 min read

Dishwasher Not Cleaning Dishes in Bremerton: Where to Look First

Dishes coming out gritty or filmy after a full cycle? Start with the spray arms and the filter, then check water temperature, detergent dosing for soft Kitsap water, and loading. This guide for Bremerton and Silverdale homes explains which fixes are yours and which need a technician.

Read the guide →
 Troubleshooting · 6 min read

Dishwasher Not Draining in Kitsap County: Safe Checks Before You Call

Standing water after the cycle usually means a blocked sump, a kinked or unlooped drain hose, a clogged air gap, or a disposal knockout that was never removed. Work through the safe checks in order, with notes for well-water homes around Manchester, and know when the pump needs a meter.

Read the guide →
 Troubleshooting · 6 min read

Gas Range Burner Won't Light: What Kitsap Homeowners Can Check

A gas burner that clicks without lighting is usually wet, dirty, or reassembled crooked. This guide covers the safe checks, the spark module and switches, propane versus natural gas around Poulsbo and the north end, and the gas-safety lines no homeowner should cross.

Read the guide →
 Tracyton

The Tracyton In-Door Ice Maker That Went Quiet

An in-door ice maker on a French-door refrigerator in a Tracyton waterfront house simply stopped, no noise and no puddle. The fill tube had frozen solid because the inlet valve passed only a trickle, and the trickle froze before it reached the mold.

Read the case →
 Ridgetop, Silverdale

The Ridgetop Front-Loader Full of Standing Water

A front-load washer in a Ridgetop townhome quit mid-cycle with six inches of water in the drum and the door locked. A morning call became a same-day visit, a manual drain, a sock pulled from the pump, and a decision about a wobbling pump.

Read the case →

Same symptom at your place?

Call any day of the week. Early calls usually get a same-day window.