Ice Maker Repair
in Poulsbo, WA
An ice maker that quietly stops is easy to ignore until the first warm weekend. Bremerton Rabbit Appliance repairs refrigerator and freezer ice makers throughout Poulsbo 7 days a week, same-day when you call before early afternoon.
Samsung and LG French-door refrigerators are everywhere in the newer Poulsbo subdivisions, and their ice makers generate a steady share of our north-end calls. The in-door ice maker on those models sits in a compartment that depends on a tight seal and a working fan, and when either slips, ice builds up around the mold until the whole assembly freezes solid. Whirlpool and KitchenAid units in the same neighborhoods have a different, more traditional ice maker with its own failure modes. Knowing which design you have is the first step, and it is why we ask for the model number when you call.
In the older houses downtown and along Liberty Bay the ice maker is often an add-on kit in a top-freezer or side-by-side Kenmore, GE or Frigidaire that has run for years. The water line behind it was installed during a remodel, sometimes with a saddle valve that has corroded in the damp, and that line is the cause of many no-ice calls here. A frozen fill tube, a clogged inlet screen or a weak inlet valve all stop water from reaching the mold. None of these are complicated, but each needs to be tested rather than assumed.
On an ice maker call in Poulsbo the technician checks the water supply pressure at the valve, the inlet valve itself, the fill tube, the ice maker mold and its thermostat or sensor, the motor and ejector, and the freezer temperature, since an ice maker will not cycle in a freezer that is not cold enough. You get a written finding and one written price before anything is replaced. Ice maker assemblies and valves for the common brands are on the van, so most repairs are finished the same visit.

Common Ice Maker Problems in Poulsbo
If the ice maker never fills, water is not getting through. The inlet valve may have failed, the fill tube may be frozen, the supply line may be kinked or shut, or a saddle valve behind the fridge has corroded closed. We test pressure and the valve coil with a meter and trace the line back to the shutoff under the sink or in the basement.
Small or hollow cubes mean a short fill, which points to low water pressure, a partly clogged inlet screen or a weak valve. Cubes fused into a block usually mean the freezer is warming slightly and refreezing, or the bin is being refilled on top of old ice. Each has a different fix, and we identify which before replacing anything.
The mold fills and freezes, then nothing. The ejector motor, the mold heater that releases the cubes, or the thermostat that tells the cycle to advance has failed. On in-door Samsung and LG units the problem is often ice built up around the auger from a leaking compartment seal. We clear it, find the cause and replace the failed part.
A leak at the back is usually the inlet valve or the fitting on the supply line. A leak inside, often under the ice bin, is a fill tube that has frozen and split or a drain problem on units with a built-in dispenser. Near the marina we find corroded fittings often enough that we check every connection on a leak call.
Bad-tasting ice almost always comes from the water, not the ice maker. An overdue filter, a line that has sat unused, or an old plastic supply tube can all do it. Ice also absorbs freezer odors if the bin has been sitting. We replace the filter if that is the issue, flush the line and tell you if the tube should be swapped.
On the Job Across Kitsap
Meters first, opinions second. The crew doing what a visit actually pays for: measured diagnosis at the machine.
What's different about ice maker repair in Poulsbo
Water lines and moisture. Many Poulsbo refrigerators in the older waterfront and hillside houses had their ice maker water line added during a remodel, routed through a damp crawl space or along an exterior wall where it gets cold and the fittings corrode. That line is the first thing we check here, because a new ice maker on a bad line is a wasted repair. In the Olhava-area homes it is the opposite problem: in-door ice makers on Samsung and LG French-door units that freeze up when a compartment seal slips. Ice maker calls ride the same north-end route as everything else in Poulsbo, 7 days a week, so an early call gets the same-day slot.
Ice Maker Repair in Poulsbo: Asked Often
Is it worth repairing the ice maker or should I just buy bagged ice?
The technician will tell you in writing what has failed and give you one price, and you decide. In most cases the fix is a valve, a fill tube or an ice maker assembly, all of which are routine. If the refrigerator itself is near the end of its life we will say so, but a dead ice maker on an otherwise healthy fridge is usually worth fixing.
My Samsung ice maker in the door keeps freezing up. Is that fixable?
Yes. The in-door ice compartment on those units depends on a seal and a small fan, and when either lets warm air in, frost builds until the auger and mold are locked in ice. We thaw it, replace the failed seal or component and check the compartment so the problem does not come back every few weeks.
The fridge was moved during our remodel and the ice maker has not worked since. Why?
That is a common Poulsbo story. Moving the refrigerator often kinks the supply tube, loosens a fitting or leaves the shutoff half open. It can also disconnect the harness to the ice maker. We check the line from the shutoff forward, reconnect what was disturbed and test the fill and cycle. Usually it is a short visit.
Can you add an ice maker to a fridge that does not have one?
If the refrigerator was built ice-maker ready, with the harness and mounting in the freezer, we can install a compatible kit and connect it to an existing water line. We do not run new plumbing through the house. Tell us the model number when you call and we will confirm whether the kit exists for it.
How soon can you get to Lemolo or Keyport for an ice maker?
The same as the rest of Poulsbo. Lemolo, Keyport and Scandia ride our north-end route, so a call before early afternoon usually gets a same-day visit and a later call gets the first opening the next morning, weekends included. Ice makers rarely need an emergency trip, but we treat them like any other repair.
Other Machines We Repair in Poulsbo
Dryer Repair in Poulsbo
Poulsbo dryers fight the dampest winters on our map. Long vent runs through crawl spaces in the hillside houses collect wet lint, and the symptom is a dryer that runs long, runs hot or stops heating. We test the element, thermostats, thermal fuse and airflow, and fix most dryers on the first visit from van stock.
Washer Repair in Poulsbo
Front-loaders near Liberty Bay are prone to mold in the door boot and a sour smell that will not wash out. Top-loaders in the older houses lose lid switches, drain pumps and suspension rods. We diagnose leaks, noise, error codes and no-spin faults anywhere in Poulsbo seven days a week.
Refrigerator & Freezer Repair in Poulsbo
A refrigerator in a damp Poulsbo kitchen works harder than one inland, and condensation hides problems until water shows up on the floor. We handle warm fridges, frozen-over freezers, failed defrost systems, noisy fans and compressors that start and stop, on every major brand from Front Street to Olhava.
Stove, Range & Oven Repair in Poulsbo
Electric and gas ranges in Poulsbo span forty years of design, from coil-top Hotpoints in the older waterfront houses to glass-top and induction models in the newer plats. We fix bake and broil elements, igniters, temperature sensors, control boards and doors that will not latch, with one written price before the work starts.
Dishwasher Repair in Poulsbo
From the built-in Bosch units in the Olhava subdivisions to the older Kenmore and Whirlpool dishwashers downtown, we repair drain failures, no-fill faults, cloudy dishes, leaks at the door and control panels that will not respond. Poulsbo calls are scheduled 7 days a week with same-day openings when you call early.
Read Next
Ice Maker Not Making Ice: What to Check in a Kitsap Home
An ice maker that goes quiet is usually stopped by something simple: a raised bail arm, a clogged filter, a frozen fill tube or a tired inlet valve. In Port Orchard homes on well water, sediment adds its own problems. Here is how to work through the causes and when to call.
Read the guide →Gas Range Burner Won't Light: What Kitsap Homeowners Can Check
A gas burner that clicks without lighting is usually wet, dirty, or reassembled crooked. This guide covers the safe checks, the spark module and switches, propane versus natural gas around Poulsbo and the north end, and the gas-safety lines no homeowner should cross.
Read the guide →LG Washer & Dryer Repair in Bremerton: Codes, Boots and Heat
LG laundry pairs are quiet, efficient and very common in Bremerton and up through Poulsbo. When they fail, they tell you with a code. This guide decodes the ones that matter, explains what a direct-drive motor does and does not break, and lists the owner checks worth doing first.
Read the guide →The Tracyton In-Door Ice Maker That Went Quiet
An in-door ice maker on a French-door refrigerator in a Tracyton waterfront house simply stopped, no noise and no puddle. The fill tube had frozen solid because the inlet valve passed only a trickle, and the trickle froze before it reached the mold.
Read the case →The Poulsbo Dishwasher That Would Not Drain on a Sunday
A dishwasher above Liberty Bay held an inch of dirty water on a Sunday morning with company due that evening. A same-day weekend visit found broken glass packed into the sump and a drain hose lying flat under the sink.
Read the case →Ice Maker down in Poulsbo?
Ice maker not keeping up in Poulsbo? Call (360) 717-8985 seven days a week and we will get it filling, freezing and dumping again.






